MagniGlide
Designed for chairs, tables, couches, side tables, bed frames, and other furniture with suitable wooden legs or wooden mounting surfaces. Suitable for straight or slightly angled legs—not heavily angled legs.
How MagniGlide works
Install the base once. Replace the felt glide when it wears.
1. Mount the base
Secure the permanent base to a compatible wooden furniture leg with the included centered screw. A screwdriver is required for this initial installation.
2. Snap on the glide
The base’s four neodymium magnets retain the replaceable floor-contact assembly through its steel interface.
3. Clean or replace the wear piece
Catch the edge with your finger and pull the assembly off. Clean it or replace it, then snap it back into place. No tools are needed for replacement, and the mounted base stays installed.
Size and fit
The complete assembly is 26 mm in diameter. The felt glide is 24 mm in diameter. Total stack height is 17 mm uncompressed, settling to approximately 15 mm after 2–4 weeks of compression.
Measure your furniture legs before installation. The wool-felt version is intended for hard-surface floors. Keep felt clean and inspect it regularly for grit and wear.
Choose the right pack
Start with a complete kit for permanent bases, felt glide pieces and mounting hardware.
Stubby drill bit included for pre-drilling
Replacement-only packs are for furniture that already has MagniGlide bases installed; bases and screws are not included.
Shop complete kits → · Shop replacement pieces →
Ships in 1–2 business days. Free U.S. standard shipping on orders of $35 or more. Unused returns within 30 days.
Protected by U.S. Patent No. 12,144,423 B1.